Hi Folks,
We are using SCM 7.0. We have a planning area which is already active (initialized) and time series have been generated. Important planning books are based on the said planning area which contains humungous data. Now, we have to change the Key figures disaggregation settings. There are some Key figures which are based on some other key figures and now we want to change it to APODPDANT. I have the below questions:
1. Can I use 'Change Key figure Settings' which is available in SCM 7.0 upgraded version?
2. Is there any chance of any inconsistencies if I go for the above option?
3. Do I have to do the changes in the target system only?
4. If I do not go through the above option, do I have to deinitialize PA, make the changes (by conventional way) and again initialize the PA and transport the request from DEV ==> Quality ==> Prod
I know these methods theoretically, but have never tried it before in the production system. Since this is a critical action, I wanted your views who have tried and tested the action successfully.
Thanks & Regards,
Sagar